A Creform NSI bi-directional AGV works as an automated tugger, traveling along a magnetic tape guidepath, slipping under a stationary cart from either direction and when necessary rotating in place.
The dual drive wheels also give this AGV higher load capacity and the ability to travel laterally. A tow pin extending into the cart’s frame conveys it to a designated workstation or unload point. One NSI AGV has the ability to mobilize multiple carts or a series of NSIs can manage an entire fleet.
The Creform model offers the most sophisticated control system available in NSI style AGVs and it’s manufactured in the U.S.A. The NSI model is programmable and can control 50 courses with up to 128 commands for each. Course programming can be accomplished with PC or an HMI (Human Machine Interface) touchscreen located on the front of the unit.
Programs can be downloaded via USB memory, Ethernet cable or RF (requires optional equipment). It’s available with an optional onboard RF communication device for traffic management, and just like all Creform units it responds to tape commands on the floor.
- PLC with HMI touchscreen.
- 50 course 128 command control, programming by PC or HMI.
- Onboard RF for traffic management. (Optional)
- Safety — audible warnings and flashing lights, obstacle sensors, non-contact laser bumpers and e-stop (emergency stops, temp stops, temp slows, 16 view sets), safety category 3.
- 24 Volt Power — full shift run under capacity load typical. Quick connector for charging. Auto charge optional.
- Powered drive wheel engage/disengage.
- Follows magnetic tape guidepath.
- RFID reader for command initiation. Command tapes initiate AGV functions such as speed changes, turns and extend/retract tow pin.
- Standard 8 bit optical communication device. Often used for remote starting.
- Service & Support: Programming, plus cart/structure designs, kitting or assembly assistance along with route layout installation available from Creform.
- Optional remote control via smart device.
